|
1.14.0182
|
Fixed defect - if a crooked lumber sensor is installed, fixed minor problem in positioning
the gripper/elevation for 2 angle leading edge cuts.
Fixed defect - If an AutoDeck is installed, fixed a problem where the deck wasn’t
being initialized after a job start.
Improvement - updated microcode provides better accuracy when homing.
Improvement - comm log is now 3 times the previous size to capture more information.
|
|
1.14.0166
|
Fixed defect - cut sequence occured where the LASM could be cut.
Fixed defect - a part with two trailing angles that had a double plunge would not
cut correctly.
Fixed defect - a Re-Do Board operation while cutting a board would cause a program
halt.
|
|
1.14.0160
|
Added feature - Under Diagnostics there is a new option for you to save/restore
constants.
Improvement - updated microcode, better accuracy in gripper and lasm.
Fixed defect - problem existed with the outfeed rollers.
Fixed defect - Key-In-Parts displayed angles incorrectly.
Fixed defect - waste wasn’t properly ejected.
Fixed defect - certain parts were not cut properly.
|
|
1.14.0155
|
Improvement - Less outfeed roller problems will now stop cutting.
|
|
1.14.0151
|
Fixed defect - elevation jams were getting reported incorrectly.
Improvement - added logic to test if the angle servo is at it’s minimum or maximum
position (possibly avoiding cutting off the LASM).
Added feature - new option to backup/restore for system constants to a folder on
another system.
|
|
1.14.0080
|
Added feature - Auto calibrate option that has a step by step process which makes
calibration easier.
Added feature- Small print characters on remainders and useables (existing remainders
will need to be reentered to get the small print).
|
|
1.14.0063
|
Added feature - Added logic for customers who will get the very latest magazine/bunk
PLC code.
Fixed defect - older magazine/bunk PLC code caused program to terminate.
Fixed defect - Key In Parts had problems with various part types.
Added feature - allow boards lengths up to the max gripper position.
Fixed defect - remove communications noise data from servo replies.
|
|
1.14.0052
|
Fixed defect - long scarfs were not being cut through properly.
Fixed defect - better control of Crooked Lumber Sensor.
Fixed defect - in some case the next part was getting cut by cuts on the previous
part.
|
|
1.14.1033
|
Added feature - remainder parts can now be any part type, and are prioritized.
Added feature - the download of new firmware is automated.
Added feature - z-pulse diagnostics screen show the current status of the z-pulse
adjustment.
Added feature - additional encoder diagnostics for diagnosing problems such as missed
counts.
Added feature - M3SC servo cards can now be swapped to aid in troubleshooting.
Added feature - the report log can be turned off if desired.
Enhancement - Main screen is painted much faster
Added feature - there is an option to have a square cut between parts on Key In
Parts which will reduce waste
|
